SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 546 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSWHEEL BEARING/HUB REPLACEMENT - FRONTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub & Splash Shield
    GM357695Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install NEW wheel bearing/hub bolts.

    Tighten:  Tighten the new wheel bearing/hub bolts to 130 N.m (96 lb ft).

  3. Install the brake rotor. Refer to Brake Rotor Replacement - Front in Disc Brakes.
  4. Install the wheel drive shaft nut. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
    5. IMPORTANT: Ensure that the connector clip engages the bracket properly.
  5. Install the wheel speed sensor electrical connector to the bracket.
    6. Fig 2: Locating Front Wheel Speed Sensor Electrical Connector
    GM625609Courtesy of GENERAL MOTORS CORP.
  6. Connect the wheel speed sensor electrical connector.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.