Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Seat Back Cushion Cover & Pad
    GM629149Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat back pad to the rear seat back frame. Refer to Seat Back Pad Replacement - Rear (Bucket)Β  or Seat Back Pad Replacement - Rear (Split Bench)Β .
  2. Install the rear seat back cushion cover. Refer to Seat Back Cover Replacement - Rear (Bucket)Β  or Seat Back Cover Replacement - Rear (Split Bench)Β .
  3. Install the rear seat back. Refer to Seat Back Replacement - Rear (Split Bench)Β  or Seat Back Replacement - Rear (Bucket)Β .
  4. Install the split bench seat. Refer to Seat Replacement - Rear 50-50 SplitΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.