SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 509 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSCOAXIAL CABLE REPLACEMENT - DIGITAL RADIOINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the antenna cable retainers to the receiver bracket.
  2. Connect the antenna cable to the digital radio receiver.
    Fig 1: View Of Antenna Cable
    GM956426Courtesy of GENERAL MOTORS CORP.
  3. Install the cable connectors to the right side end cap on the I/P.
    4. Fig 2: Locating Cable Connectors Inside Of Instrument Panel (I/P)
    GM1132274Courtesy of GENERAL MOTORS CORP.
  4. Install the right rear compartment trim panel.
  5. Install the antenna cable retainer clips.
    6. Fig 3: View Of Antenna Base Assembly
    GM956421Courtesy of GENERAL MOTORS CORP.
  6. Connect the antenna cable to the antenna base cable connector.
  7. Install the headliner. Refer to Headliner Replacement (Rendezvous) or Headliner Replacement (Aztek) in Interior Trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.