SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 451 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENT (AZTEK)INSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the high mounted stop lamp plastic retainer nuts to the roof panel pressing into place until fully seated.
    Fig 1: High Mounted Stop Lamp Installation - Aztek (1 Of 3)
    G01515520Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the high mounted stop lamp.
  3. Position the high mounted stop lamp retainer tabs to the slots in the roof panel.

    Press the high mounted stop lamp in place until fully seated.

    Fig 2: High Mounted Stop Lamp Installation - Aztek (2 Of 3)
    G01515521Courtesy of GENERAL MOTORS CORP.
  4. Install the screws to the high mounted stop lamp.

    Tighten 

    Tighten the high mounted stop lamp screws to 2 N.m (18 lb in).

    Fig 3: High Mounted Stop Lamp Installation - Aztek (3 Of 3)
    G01515522Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.