Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. Refer to SEAT REPLACEMENT - BUCKETΒ  .
  2. Remove the front seat back. Refer to SEAT BACK REPLACEMENT - FRONTΒ  .

    Important:Β  Remove the front seat cover and pad as one piece, if replacing the front seat back frame only.

  3. Remove the front seat back cushion cover. Refer to SEAT BACK COVER REPLACEMENT - FRONTΒ  .
  4. Remove the front seat back pad from the front seat back frame. Refer to SEAT BACK PAD REPLACEMENT - FRONTΒ  .
  5. Remove the front seat lumbar from the front seat back, if required. Refer to LUMBAR REPLACEMENT - FRONT SEATΒ  .
    Fig 1: Removing Front Seat Back Frame
    G01518077Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.