Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 440 (SEAT SYSTEM)REPAIR INSTRUCTIONSLUMBAR REPLACEMENT - FRONT SEATINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the lumbar support to the mounting holes in the front seat back.
Install the lumbar support to the front seat back, pressing into place until fully seated.

Fig 1: Installing Lumbar Support To Front Seat Back
Courtesy of GENERAL MOTORS CORP.
Install the lumbar support cable to the lumbar support control.

Fig 2: Installing Lumbar Support Cable To Lumbar Support Control (1 Of 2)
Courtesy of GENERAL MOTORS CORP.
Install the lumbar support cable to the lumbar support control.
Install the front seat back pad. Refer to SEAT BACK PAD REPLACEMENT - FRONT .
Install the front seat back cover. Refer to SEAT BACK COVER REPLACEMENT - FRONT .
Install the front seat. Refer to SEAT REPLACEMENT - BUCKET .

Fig 3: Installing Lumbar Support Cable To Lumbar Support Control (2 Of 2)
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.