SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 399 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENTREMOVAL PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side windshield garnish molding. Refer to GARNISH MOLDING REPLACEMENT -- WINDSHIELD PILLAR .
  2. Remove the center pillar trim panel. Refer to GARNISH MOLDING REPLACEMENT -- CENTER PILLAR .
  3. Remove the right rear upper quarter trim panel. Refer to TRIM PANEL REPLACEMENT -- REAR QUARTER UPPER .
  4. Remove the upper instrument panel trim pad. Refer to TRIM PAD REPLACEMENT -- IP UPPER .
  5. Lower the headliner in order to gain access to the coaxial cable harness along the right side of the vehicle. Refer to HEADLINER REPLACEMENT (WITH SUNROOF) or HEADLINER REPLACEMENT (WITHOUT SUNROOF) .
  6. Disconnect the coaxial cable connectors (2).
    7. Fig 1: Disconnecting Coaxial Cable Connectors
    G01801112Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the ground cable (1) from the roof beam.
  8. Disconnect the antenna connection (2) at the windshield.
    Fig 2: Disconnecting Antenna Connection
    G01801113Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the coaxial cable from the antenna module located on the rear roof beam.
    Fig 3: Disconnecting Coaxial Cable From Antenna Module
    G01801114Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the power lead connection (2).
  11. Remove the rosebud clips (3) from the roof beams.
  12. Remove the coaxial cable harness from the vehicle.
    Fig 4: Removing Coaxial Cable Harness
    G01801115Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.