SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 381 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSHEATED SEAT CONTROL MODULE REPLACEMENT - FRONTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the heater module to the front seat.
  2. Connect the electrical harness connector (1) to the heater module (2).
    3. Fig 1: Identifying Heater Module Electrical Harness Connector
    G01756146Courtesy of GENERAL MOTORS CORP.
  3. Position the module on the frame and slide the module rearward until the module locks into place.
  4. Lower the seat.
  5. Connect the seat electrical harness connector.
    NOTE: Refer to FASTENER NOTICE .
  6. Install the bolts that secure the front bucket seat adjuster to the floor pan. Tighten the bolts to 42 N.m (31 lb ft).
  7. Reposition the front seat to the original position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.