Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 148 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL CABLE REPLACEMENT (3. 1L)INSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Position the cruise control cable to the engine.
Important: Ensure the cruise control module strap is not twisted during installation of the cruise control cable.

Fig 1: Positioning Cruise Control Cable To Engine

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable to the cruise control module by rotating the cruise control cable clockwise.

Fig 2: Installing Cruise Control Cable To Cruise Control Module

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable to the cruise control retainers.
Install the cruise control cable to the cruise control module strap.

Fig 3: Identifying Cruise Control Module Strap

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable to the throttle lever and the accelerator control cable bracket.

Fig 4: Identifying Cruise Control Cable At Throttle Lever & Accelerator Control Cable Bracket

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.