Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 4.3L)PROGRAMMINGTHEFT DETERRENT PASSWORD LEARN PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Theft Deterrent Password Learn Procedure
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Theft Deterrent Password Learn Procedure
WARNING: This page is about a different variant/trim than selected.
NOTE:
This procedure allows relearning of Passlock™ module or PCM learned data code after replacement of Passlock™ module, Passlock™ sensor or PCM. DTC B3031 will set when entering programming mode.
- Clear all DTCs. Turn ignition off. Replace component(s) as necessary.
- With transmission in Park (A/T) or Neutral (M/T), momentarily turn ignition switch to START position (engine will not start). Leave ignition switch in RUN position (engine off). If Passlock™ sensor was replaced, SECURITY indicator light will flash for 10 minutes. If Passlock™ module was replaced, SECURITY indicator light will flash for a few seconds, and then remain on for 10 minutes. If PCM was replaced with a new PCM, vehicle may start and procedure may not be needed. If replacement PCM was used even momentarily, SECURITY indicator light will flash for a few seconds, and then remain on for 10 minutes. After 10 minutes, when light turns off, turn ignition switch to OFF position for 5 seconds.
- Repeat step 2 twice more. Ignition switch must be turned to OFF position. Auto learn procedure will be completed during next start attempt. Clear all DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.