Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Aids
Intermittent DTCs P0251, P0370 and P1216 may be caused by air entering fuel system when fuel level is less than 1/8 tank while performing hard acceleration or turning maneuvers. If vehicle runs out of fuel, DTCs P0251, P0370 and P1216 will set. If vehicle has been operating under these conditions, bleed air from fuel system and test drive vehicle. Fast idle and poor performance will exist when PCM is in back-up fuel (less than 1/8 tank). If DTC P0251 is also set, use scan tool in snapshot mode to properly identify fault. DTCs P0335, P1216 and P1217 may also set with DTC P0370. PCM is the least likely cause of failure.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.