SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 819 (POWER STEERING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC SYSTEM CHECK - POWER STEERING SYSTEMTEST DESCRIPTION
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Test Description

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Test Description
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  The lack of communication may be caused by a partial or a total malfunction of the circuit containing the class 2 serial data. The specified procedure will determine the particular condition.
  2. 3:  The presence of DTCs which begin with a U indicate some other module is not communicating. The specified procedure will collect all the available information before tests are performed.
  3. 5:  Tests if a malfunction exists in the EPS system.
  4. 6:  Tests if the steering column shaft is bent, twisted or damaged due to a previous collision and or air bag deployment.
Diagnostic System Check - Power Steering System

Step Action Value(s) Yes No
1 Install a scan tool.
Does the scan tool turn on?		 - Go to Step 2  Go to Scan Tool Does Not Power Up in Data Link Communications
2 
  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the Power Steering Control Module (PSCM).
Does the scan tool communicate with the PSCM?		 - Go to Step 3  Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications
3  Select the Diagnostic Trouble Codes (DTC) function on the scan tool.
Does the scan tool display any DTCs that begin with a U?		 - Go to Diagnostic Trouble Code (DTC) List in Data Link Communications Go to Step 4 
4 Does the scan tool display DTC C0550? - Go to Diagnostic Trouble Code (DTC) List in Body Control Systems Go to Step 5 
5  Does the scan tool display any EPS DTCs? - Go to Diagnostic Trouble Code (DTC) List  Go to Step 6 
6 
  1. Start the engine.
  2. Turn the steering wheel 90° to the left, then 90° to the right, then return the steering wheel to center.
  3. Remove hands from steering wheel and ensure no force is being applied to the steering wheel.
  4. Using the scan tool observe the Torque Sensor Main data parameter in the EPS data list.
Does the scan tool indicate that the Torque Sensor Main data parameter is less than the specified range?		 < + or - 1 N.m (0.7 lb ft) Go to Symptoms - Power Steering System  Go to Steering Column Replacement in Steering Wheel and Column
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.