Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 792 (BODY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESON-BOARD DIAGNOSTIC FEATURESOUTPUT TESTING
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Output Testing
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Output Testing
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure the BCM is in self-test and you have retrieved DTCs.
- Turn the IP dimmer switch to the DOME position to begin the first output test.
- Turn the IP dimmer switch from DOME to OFF and back to DOME to step through the 7 tests listed:
- Test 1 - turns OFF all interior lamps
- Test 2 - turns ON the interior lamps
- Test 3 - turns ON all courtesy lamps
- Test 4 - energizes the theft deterrent relay for 1 second and turns ON the headlamps, for BCM Type 4 only
- Test 5 - energizes the horn relay for 25 ms and turns ON the horn, for BCM Type 4 only
- Test 6 - turns ON the theft deterrent indicator lamp, for BCM Type 4 only
- Test 7 - turns OFF the theft deterrent indicator lamp, for BCM Type 4 only
- The BCM sounds the chime to indicate the output test number.
- Once all tests are completed, the cycle will repeat with each DOME-OFF-DOME cycle of the IP dimmer switch.
Remember that the maximum number of output tests for Type 2 and Type 3 BCMs is 3.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.