Component Locations (4.0L VIN C - Aurora)

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Component Locations (4.0L VIN C - Aurora)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, 2002 Saturn SC2, and 2002 Saturn SC1. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS (4.0L VIN C - AURORA)

Component Location
Camshaft Position Sensor On Front Of Right Cylinder Head
Crankshaft Position Sensor "A" & "B" Lower Left Side Of Engine Near Oil Filter
Engine Coolant Temperature Sensor Left Rear Of Engine, Below EGR Mount
Engine Oil Level Switch Front Of Oil Pan
Engine Oil Pressure Sensor Right Front Side Of Engine, Near Oil Filter Housing
EVAP Canister Purge Solenoid On Top Of Engine, At Rear Of Throttle Body
Exhaust Gas Recirculation Valve On Top Of Engine, Rear Of Intake Manifold
Fuel Sender Top Of Fuel Tank
Fuel Tank Pressure Sensor Under Fuel Sensor Access Panel
Idle Air Control Valve On Top Of Engine, At Front Of Throttle Body
Ignition Control Module (Right & Left) Top Of Right & Left Cam Covers
Knock Sensor On Engine, Beneath Intake Manifold
Manifold Absolute Pressure Sensor Top Rear Of Engine, At Rear of Intake Manifold
Mass Airflow Sensor On Left Side Of Engine Compartment, Attached To Throttle Body Intake Air Duct
Post-Converter Oxygen Sensor On Exhaust Pipe Behind Catalytic Converter
Powertrain Control Module Left Side Of Engine Compartment, Under Air Cleaner
Pre-Converter Oxygen Sensors In Front & Rear Exhaust Manifolds
Throttle Position Sensor On Top Right Side Of Engine, Near Throttle Body
Vehicle Speed Sensor Top Right Side Of Transaxle Output Housing
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.