Suspension Controls Component Views

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Suspension Controls Component Views
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cockpit Component View
GM698492Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Outside Rearview Mirror-Driver
2 Fog Lamp/Rear Compartment Lid Release Switch (Domestic), Fog Lamp Switch (Export)
3 Dimmer Switch
4 Dimmer/Head Up Display (HUD) Switch
5 Instrument Panel Cluster (IPC)
6 Vanity Mirror Lamp-Left
7 Driver Information Center (DIC) Switch-Right
8 Hazard Switch
9 Radio
10 HVAC Control Module
11 Vanity Mirror Lamp-Right
12 Door Switch-Passenger
13 Outside Rearview Mirror-Passenger
14 Footwell Courtesy Lamp-Right
15 Fuel Door Lock Release Switch (Domestic), Rear Compartment Lid/Fuel Door Lock Release Switch (Export)
16 Traction/Suspension Control Switch
17 Auxiliary Power Outlet Connector
18 Cigar Lighter
19 Horn Switch
20 Seat Control Module (SCM)-Driver (W/Memory Seats), Seat Relay Center-Driver (W/O Memory Seats)
21 Seat Adjuster Switch-Driver
22 Footwell Courtesy Lamp-Left
23 Door Switch-Driver
Fig 2: Suspension Components Component View - Sensors And Dampers
GM903051Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Suspension Position Sensor - RF
2 Suspension Damper - RF
3 Suspension Damper - RR
4 Suspension Position Sensor - RR
5 Suspension Damper - LR
6 Suspension Position Sensor - LR
7 Suspension Position Sensor - LF
8 Suspension Damper - LF
Fig 3: Luggage Compartment Component View
GM901381Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Electronic Suspension Control (ESC) Module
2 Rear Compartment Courtesy Lamp - Left
3 Remote Playback Device - CD Changer
4 Rear Compartment Courtesy Lamp - Right
5 Rear Compartment Lid Ajar Switch
6 Rear Compartment Lid Latch (Hardtop/Convertible)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.