Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 716 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK RECLINER MECHANISM REPLACEMENT - FRONTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not lubricate the seatback recliner mechanism.

Fig 1: Recliner Mechanism To Seat Frame

GM171527

Courtesy of GENERAL MOTORS CORP.

Install the recliner mechanism to the seat frame.
Install the cables to the actuators.
Securely snap the cable retaining clips to the actuators with the tabs up.

Fig 2: View Of Seat Cushion Frame

GM71217

Courtesy of GENERAL MOTORS CORP.

Install the seat adjusters to the seat if removed.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Apply Loctite™ 271 to the bolts and secure the adjuster to the seat.
Tighten: Tighten the bolts to 24 N.m (18 lb in).

Fig 3: Actuators Underneath Seat Frame Springs

GM71219

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.