SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 617 (INSTRUMENT PANEL, GAGES, AND CONSOLE)REPAIR INSTRUCTIONSHEAD UP DISPLAY SWITCH REPLACEMENTREMOVAL PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT  . 
  2. Disconnect the instrument panel (IP) dimmer/head-up display (HUD) switch electrical connector.
    Fig 1: Disconnecting Instrument Panel Dimmer/Head-Up Display Switch Electrical Connector
    G01453836Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the driver information center (DIC) switch electrical connector.
    Fig 2: Disconnecting Driver Information Center Switch Electrical Connector
    G01453837Courtesy of GENERAL MOTORS CORP.
  4. Remove the IP cluster bezel retaining screws.
  5. Remove the bezel from the IPC.
    Fig 3: Removing Bezel From Instrument Panel Cluster
    G01453838Courtesy of GENERAL MOTORS CORP.
  6. Remove the IP dimmer/HUD switch retaining screws.
  7. Remove the IP dimmer/HUD switch.
    Fig 4: Removing Instrument Panel Dimmer/Head-Up Display Switch
    G01453839Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.