Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 613 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER TRANSMISSION REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Position the wiper transmission to the wiper motor module assembly.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the wiper transmission screws.
Tighten Tighten the screws to 10 N.m (89 lb in).

Fig 1: Wiper Transmission Screws
Courtesy of GENERAL MOTORS CORP.
Using the J 39529, connect the wiper transmission to the wiper motor crank arm.
Install the wiper drive system module. Refer to WIPER DRIVE SYSTEM MODULE REPLACEMENT .
Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in Body Front End.
Install the wiper arms. Refer to WIPER ARM REPLACEMENT .

Fig 2: Connecting Wiper Transmission To Wiper Motor Crank Arm Using Wiper Linkage Installer
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.