Sensing & Diagnostic Module (SDM): Removal

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1999 GMC Savana Special, 1999 GMC Savana Camper Special, 1999 GMC Savana, 1999 Chevrolet RV Cutaway, and 1999 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see SERVICE PRECAUTIONSΒ  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEMΒ  .
  2. Remove driver seat. Fold back carpet to access SDM. Remove Connector Position Assurance (CPA) clip and disconnect SDM harness connector. Remove SDM fasteners. See Figure . Remove SDM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.