Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 545 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTABILIZER SHAFT INSULATOR REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the stabilizer shaft insulator.

Fig 1: View Of Left And Right Stabilizer Shaft Insulators And Brackets

Courtesy of GENERAL MOTORS CORP.

Ensure that the stabilizer shaft insulator locating tabs (3) align with the indentations in the frame (2).
Install the left and right side stabilizer shaft insulator brackets.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the left and right side stabilizer shaft insulator bracket bolts.
Tighten: Tighten the stabilizer shaft insulator bracket bolts to 48 N.m (35 lb in).
Install the front tires. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.