Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rearview Mirror Electrical Connector
    GM311618Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (3) from the back of the mirror.
  2. Remove the wire harness cover.
  3. Adjust the mirror to the full upward position.
  4. Remove the base trim cover.
  5. Fig 2: Removing/Installing Rearview Mirror
    GM330783Courtesy of GENERAL MOTORS CORP.
  6. Loosen the screw at the base in order to remove the mirror from the button.
  7. Slide the mirror in an upward motion in order to remove.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.