SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 537 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWASHER SOLVENT CONTAINER REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Washer Solvent Container Screws
    GM697662Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the right side engine compartment.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    3. Fig 2: View Of Washer Solvent Container Level Sensor Electrical Connector
    GM774666Courtesy of GENERAL MOTORS CORP.
  3. Connect the washer solvent container level sensor electrical connector.
    4. Fig 3: View Of Washer Solvent Container Components
    GM771826Courtesy of GENERAL MOTORS CORP.
  4. Connect the rear washer pump electrical connector if equipped.
  5. Connect the washer hose to the rear washer pump if equipped.
    6. Fig 4: Identifying Front Washer Pump Electrical Connector
    GM697664Courtesy of GENERAL MOTORS CORP.
  6. Connect the front washer pump electrical connector.
  7. Connect the front washer hose to the front washer pump.
  8. Fill the washer solvent container with washer solvent.
  9. Install the battery. Refer to Battery Replacement in Engine Electrical.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.