SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 528 (ACCESSORY POWER SOCKET)REPAIR INSTRUCTIONSACCESSORY POWER RECEPTACLE REPLACEMENT - 12 VOLTREMOVAL PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 12-volt power supply fuse.
  2. Remove the 12-volt power supply receptacle by placing one side of the "T" portion of J 42059  into the tab window. Angle the other side into the opposite tab window. Pull the 12-volt power supply receptacle straight out.
    3. Fig 1: Inserting J 42059 Into 12-Volt Power Supply Receptacle
    GM706160Courtesy of GENERAL MOTORS CORP.
  3. Remove J 42059  from the power supply receptacle.
  4. Disconnect the electrical connector from the power supply receptacle.
    Fig 2: Locating 12-Volt Power Supply Receptacle Electrical Connector
    GM706165Courtesy of GENERAL MOTORS CORP.
  5. Using your index finger, pull out the power supply retainer.
    Fig 3: Locating Power Supply Retainer
    GM706167Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.