Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 519 (STEERING WHEEL & STEERING COLUMN)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Disable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.

Fig 1: Identifying Steering Wheel Rear Bezel Retaining Screws

Courtesy of GENERAL MOTORS CORP.

Remove the steering wheel. Refer to Steering Wheel Replacement .
Remove the retaining screws (2, 3) from the steering wheel rear bezel.
Remove the steering wheel rear bezel (1).

Fig 2: View Of Inner Steering Wheel Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector.
Insert a small, blunt-ended tool into the access hole in the back of the steering wheel. Push the switch out of the steering wheel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.