Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 502 (BODY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Scan Tool Data List
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Scan Tool Data List
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF/Doors Hatch Closed/No Switches Pressed | |||
| 8 Digit GM Part Number | Module Information | 8 digits | xxxxxxxx |
| Accessory | Data | Volts | 0.0-25.5 |
| Electronics Battery Fd | Data | Volts | 0.0-25.5 |
| Ignition 0 | Data | Volts | 0.0-25.5 |
| Ignition 0 | Input | Active, Inactive | Active |
| Ignition 1 | Input | Active, Inactive | Active |
| Ignition Accessory | Input | Active, Inactive | Active |
| Key In Ignition | Input | Active, Inactive | Active |
| Park/Neutral Switch | Input | Active, Inactive | Active |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.