Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 496 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT SWITCH REPLACEMENT - POWERREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the seat from the vehicle. Refer to SEAT REPLACEMENT - Bucket or SEAT REPLACEMENT - Bench .
Remove the 3 screws securing the trim panel to the seat.

Fig 1: Removing Screws Securing Trim Panel To Seat
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector from the switch.

Fig 2: Disconnecting Electrical Connector From Switch
Courtesy of GENERAL MOTORS CORP.
Remove the switch from the trim panel by snapping the switch out of the plastic retaining tabs.
Remove the switch assembly.

Fig 3: Removing Switch From Trim Panel By Snapping Switch Out Of Plastic Retaining Tabs
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.