Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION in Cautions and Notices.
  1. Disconnect the battery negative cable.
  2. Disconnect the cruise control cable. Refer to CRUISE CONTROL CABLE REPLACEMENT (4.3L)Β  or CRUISE CONTROL CABLE REPLACEMENT (2.2L)Β .
  3. Disconnect the electrical connector.
  4. Remove the 3 nuts that retain the cruise control module to the mounting bracket studs.
  5. Remove the cruise control module from the mounting bracket.
  6. Remove the 3 screws that retain the mounting bracket to the cowl panel.
    Fig 1: Removing Mounting Bracket To Cowl Panel Retaining Screws
    G01477297Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.