Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 472 (STEERING WHEEL & STEERING COLUMN)
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Section 472 (Steering Wheel & Steering Column)
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Section 472 (Steering Wheel & Steering Column)
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Symptoms - Steering Wheel and Column
- Ignition Can/Cannot Be Turned Off with Transmission in Any Gear
- Lock System Does Not Unlock
- Lock System Does Not Lock
- Lock System Sticks in Start
- Key Cannot Be Removed in the Off Lock Position
- High Lock Effort
- Noise in Steering Column
- High Shift Effort
- Looseness in Steering Column
- Steering Column Tilt Function Inoperative
- Repair Instructions
- Seal Replacement - Intermediate Steering Shaft
- Intermediate Steering Shaft Replacement - Upper
- Intermediate Steering Shaft Replacement - Lower
- Steering Column Accident Damage Inspection
- Steering Column Trim Covers Replacement
- Ignition Switch Replacement
- Ignition Lock Cylinder Replacement
- Ignition Lock Cylinder Case Replacement (Floor Shift)
- Ignition Lock Cylinder Case Replacement (Column Shift)
- Multifunction, Turn Signal Switch Replacement
- Shift Lever Replacement
- Linear Shift Assembly Replacement
- Tilt Lever Replacement
- Horn Switch Replacement
- Steering Wheel Replacement
- Tilt Spring Replacement
- Turn Signal Cancel Cam and Upper Bearing Thrust Washer
- Steering Column Replacement
- Lower Bearing and Steering Column Jacket Replacement (Floor Shift Standard)
- Inflatable Restraint Steering Wheel Module Coil Centering
- Description and Operation
- Special Tools & Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.