Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 448 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF SWITCH REPLACEMENTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Use a small flat-bladed tool to disengage the retainer clips located at the front and rear of the power sunroof switch. Hold the flat-bladed tool parallel to the roof and push straight in.

Fig 1: Disengaging Retainer Clips
Courtesy of GENERAL MOTORS CORP.
Rotate the power sunroof switch toward the left side to disengage the retainer clips from the mounting bracket and pull down.

Fig 2: Rotating Power Sunroof Switch Toward Left Side
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector from the power sunroof switch.

Fig 3: Disconnecting Electrical Connector From Power Sunroof Switch
Courtesy of GENERAL MOTORS CORP.
Remove the power sunroof switch from the bezel.

Fig 4: Removing Power Sunroof Switch From Bezel
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.