SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 438 (INSTRUMENT PANEL, GAGES, AND CONSOLE)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Fastener Tightening Specifications

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Air Distribution Extension Duct Bolts 2 N.m 18 lb in
Arm Rest Screws 2 N.m 18 lb in
Assist Handle Nuts 8 N.m 71 lb in
Audio System Bolts 2 N.m 18 lb in
Cross Car Beam at Hinge Pillars Bolts 25 N.m 18 lb ft
Data Link Connector Bolts 2 N.m 18 lb in
Front Floor Console Front Mounting Point Bolts 6 N.m 53 lb in
Front Floor Console Rear of Storage Compartment Base Bolts 6 N.m 53 lb in
Front Floor Console Rear of Transaxle Shift Lever Bolts 6 N.m 53 lb in
Heads Up Display Bolts 2 N.m 18 lb in
Heater A/C Control Bolts 2 N.m 18 lb in
Hood Release Handle Base Bolts 2 N.m 18 lb in
Instrument Panel Cluster Bolts 2 N.m 18 lb in
Instrument Panel Cluster Trim Plate Bolts 2 N.m 18 lb in
Instrument Panel Compartment Bolts 2 N.m 18 lb in
Instrument Panel Compartment Door Retractor Cord Bolt 2 N.m 18 lb in
Instrument Panel Compartment Hinge Bolts 4 N.m 35 lb in
Instrument Panel Compartment Latch Bolts 2 N.m 18 lb in
Instrument Panel Forward Extension Compartment Bolts 2 N.m 18 lb in
Instrument Panel Trim Pad at Lower Hinge Pillars Bolts 20 N.m 15 lb ft
Instrument Panel Trim Pad at Windshield Bolts 5 N.m 44 lb in
Overhead Console Screws 2 N.m 18 lb in
Steering Column Bracket Bolts 6 N.m 53 lb in
Trim Plate Screws 2 N.m 18 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.