Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 434 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSWHEEL BEARING/HUB REPLACEMENT - FRONTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the wheel bearing/hub.
Install NEW wheel bearing/hub bolts.
Tighten Tighten the new wheel bearing/hub bolts to 130 N.m(96 lb ft).
Install the brake rotor. Refer to BRAKE ROTOR .
Install the wheel drive shaft nut. Refer to AXLE SHAFT in Front Axle.
Important: Ensure that the connector clip engages the bracket properly.

Fig 1: Installing Wheel Bearing/Hub
Courtesy of GENERAL MOTORS CORP.
Install the wheel speed sensor electrical connector to the bracket.
Connect the wheel speed sensor electrical connector.
Install the tire and wheel.
Lower the vehicle.

Fig 2: Connecting Wheel Speed Sensor Electrical Connector
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.