Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 429 (PERSONALIZATION SYSTEMS)DESCRIPTION AND OPERATIONDRIVER PERSONALIZATIONPROGRAMMING FEATURES WITH THE DRIVER INFORMATION CENTER (DIC)ENTER PROGRAMMING
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Enter Programming
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Enter Programming
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
To enter programming with the DIC, perform the following actions:
- Turn the ignition to RUN.
- Place the vehicle in PARK.
- Press the LOCK button on the keyless entry transmitter whose number corresponds to the correct driver for this session of personalization.
- Press the MODE button for the DIC until the DIC displays PERSONALIZATION FOR DRIVER #, where # equals the current driver number.
- Press the SET button for the DIC to enter programming mode.
The PROGRAM MODE indicator illuminates providing the status.
- The DIC displays PRESS MODE FOR NEXT OPTION and then PRESS SET TO CHANGE OPTION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.