Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place forefinger under the lower rear edge of the switch plate.
  2. Place thumb at the upper rear end of the switch plate along the curved surface.
  3. While pulling rearward with forefinger and holding pressure with thumb, flex and lift the rear of the switch plate upwards.
  4. Insert a small flat bladed tool under the forward edge of the switch plate.
  5. Gently pry the forward edge of the switch plate upwards.
  6. Fig 1: Removing Rear Door Window Switch
    G01803488Courtesy of GENERAL MOTORS CORP.
  7. Lift the entire switch plate upwards to remove.
  8. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.