Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK RECLINER REPLACEMENT - FRONT (POWER)INSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Slide the recliner assemblies into the seat adjuster tracks.
CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
Install the recliner fasteners.
Tighten

Tighten the fasteners to 50 N.m (37 lb ft).
Install the outboard seat adjuster track reinforcement bracket.
Install the reinforcement bracket fasteners.
Tighten

Tighten the fasteners to 50 N.m (37 lb ft).
Install the recliner motor and sensor if equipped. Refer to Power Recliner Motor Replacement - Front Seat .
Install the seat back frame. Refer to Seat Back Frame Replacement - Front .

Fig 1: Locating Seat Back Recliner
Courtesy of GENERAL MOTORS CORP.
Connect the lumbar electrical connector.
Install the adjuster track covers. Refer to Seat Adjuster Track Cover Replacement - Front .
Install the seat cushion. Refer to Seat Cushion Replacement - Front .
Install the front seat. Refer to Seat Replacement - Bucket .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.