Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 383 (BUMPER SYSTEM)REPAIR INSTRUCTIONSBRACKET REPLACEMENT - FRONT BUMPERINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Install the front bumper impact bar bracket to the vehicle.
CAUTION: Refer to FASTENER NOTICE .
Install the fasteners to secure the front of the front bumper impact bar bracket.
Tighten

Tighten the fasteners to 50 N.m (37 ft lbs).
Install the fastener to secure the rear of the front bumper impact bar bracket.
Tighten

Tighten the fastener to 50 N.m (37 ft lbs).
Install the front impact bar. Refer to IMPACT BAR REPLACEMENT - Front Bumper . .
Install the front bumper fascia. Refer to FASCIA REPLACEMENT - Front Bumper . .

Fig 1: Installing Front Bumper Bracket
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.