Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat cushion outer trim panel. Refer to Trim Panel Replacement - Front SeatΒ .
  2. Remove the screws from the seat switch to the trim panel.
    Fig 1: Identifying Seat Switch-To-Trim Panel Screws
    G01756137Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector from the power front seat switch.
  4. Fig 2: Removing Power Front Seat Switch Electrical Connector
    G01756138Courtesy of GENERAL MOTORS CORP.
  5. Remove the power front seat switch from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.