Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the studs to the rear window panel slots and slide into place.
    NOTE: Refer to FASTENER NOTICE .
  2. Tighten the low frequency audio amplifier nuts. Tighten the low frequency audio amplifier nuts to 6 N.m (53 lb in).
  3. Fig 1: Identifying Amplifier
    G01755077Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connectors to the low frequency audio amplifier.
  5. Install the rear seat sound barrier. Refer to SOUND BARRIER REPLACEMENT - REAR SEAT BACK .
  6. Install the rear shelf trim panel. Refer to TRIM PANEL REPLACEMENT - REAR WINDOW SHELF .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.