SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 355 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSSPEAKER REPLACEMENT - REARINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear header speaker to the rear header speaker housing.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the screws in order to retain the rear header speaker to the rear header speaker housing.

    Tighten 

    Tighten the screws in order to retain the rear header speaker to the speaker housing to 2 N.m (18 ft lbs).

  3. Connect the electrical connector to the speaker.
  4. Install the rear header speaker housing to the vehicle.
  5. Install the nuts in order to retain the rear header speaker housing to the vehicle.

    Tighten 

    Tighten the nuts in order to retain the rear header speaker housing to the vehicle to 6 N.m (53 in lbs).

    Fig 1: Installing Rear Header Speaker Components
    G01736450Courtesy of GENERAL MOTORS CORP.
  6. Install the rear header trim panel, if equipped.
Fig 2: Installing Rear Header Trim Panel
G01736451Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.