Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Using Radio-Operated Communication Devices While Operating the VCP
Operating a mobile or permanently-mounted communication device in or near the vehicle while the VCP is on may cause objectionable video distortion. Examples of these communication devices are:
- Cellular telephones
- Scanners
- CB radios
- Walkie-talkies
- Two-way radios
- Mobile fax devices
- Global positioning system (GPS) systems (excluding the OnStar® system)
In some cases, radio wave distortion may or may not be noticed at either the device or the entertainment system.
Therefore, whenever operating a communication device in or around the vehicle, it may be necessary to turn off the VCP, or operate the device outside and away from the vehicle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.