Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the gasket.
  2. Install the water pump.
  3. Install the water pump bolts.

    Tighten:Β 

    Tighten the bolts to 10 N.m (89 in lbs)Β 

    Fig 1: Water Pump And Components
    G01764814Courtesy of GENERAL MOTORS CORP.
  4. Install the water pump pulley.
  5. Install the water pump pulley bolts.

    Tighten:Β 

    Tighten the bolts to 25 N.m (18 ft lbs)Β 

    Fig 2: Water Pump Pulley Bolts
    G01764815Courtesy of GENERAL MOTORS CORP.
  6. Install the drive belt. Refer to DRIVE BELT REPLACEMENT
  7. Install the drive belt guard.
  8. Fill the cooling system. Refer to Draining and Filling Cooling SystemΒ 
  9. Inspect for leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.