Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 332 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSWHEEL BEARING/HUB REPLACEMENT - FRONTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Install the wheel bearing/hub.
WARNING: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
Install NEW wheel bearing/hub bolts.
Tighten:

Tighten the NEW wheel bearing/hub bolts to 130 N.m (96 lb ft)

Fig 1: Wheel Bearing/Hub Bolts And Assembly
Courtesy of GENERAL MOTORS CORP.
Install the axle shaft nut. Refer to AXLE SHAFTS .
Install the brake rotor. Refer to BRAKE ROTOR (FRONT) .
Install the brake caliper bracket with the brake caliper. Refer to CALIPER BRACKET (FRONT) .
NOTE: Ensure that the connector clip engages the bracket properly.
Install the wheel speed sensor electrical connector to the bracket.

Fig 2: Wheel Speed Sensor Electrical Connector To Bracket
Courtesy of GENERAL MOTORS CORP.
Connect the wheel speed sensor electrical connector (2).

Fig 3: Wheel Speed Sensor Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the tire and wheel.
Lower the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.