Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 332 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTABILIZER SHAFT REPLACEMENTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or intermediate shaft. This damage can cause loss of steering control which could result in personal injury.

Raise and suitably support the vehicle.
Remove the left tire and wheel assembly.
Remove the pinch bolt from the lower intermediate steering shaft. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT .
Loosen all insulator clamp attaching bolts.
Place a jackstand under the center of the rear frame crossmember.
Remove the rear frame-to-body bolts.
Lower the rear of the frame just enough to gain access to the stabilizer shaft.
Remove the insulator clamp bolts and the clamps from the frame.

Fig 1: Insulator Clamp Bolts
Courtesy of GENERAL MOTORS CORP.
Remove the insulators from the stabilizer bar.

Fig 2: Insulators
Courtesy of GENERAL MOTORS CORP.
Remove the stabilizer bar links from the control arms. Refer to Stabilizer Shaft Link Replacement .

Fig 3: Stabilizer Bar Links
Courtesy of GENERAL MOTORS CORP.
Pull the stabilizer shaft rearward.
Swing the stabilizer shaft down to remove the stabilizer shaft from the left side of the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.