Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 329 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSCHECKING AND ADDING POWER STEERING FLUID
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Checking and Adding Power Steering Fluid
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Checking and Adding Power Steering Fluid
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.
- Clean the area surrounding the reservoir cap.
- Remove the reservoir cap.
- Inspect the power steering pump fluid level at regular intervals. Add fluid when required.
- If the fluid level is being checked cold, perform the following steps:
- Remove the reservoir cap.
- Inspect the fluid level on the dipstick.
- The fluid level should be between the bottom of the COLD/FULL mark and the end of the dipstick.
- If the fluid level is being checked hot, perform the following steps:
- Run the engine until the fluid reaches about 80°C (170°F).
- Turn OFF the engine.
- Remove the reservoir cap.
- Inspect the fluid level on the dipstick.
- The fluid level should be between the HOT/FULL and the COLD/FULL marks on the dipstick.
- If the fluid level is being checked cold, perform the following steps:
- If the fluid level is low, add the power steering fluid to the proper level.
- Install the reservoir cap.
- When you inspect the fluid level after servicing the steering system, bleed the air from the system. Refer to Bleeding the Power Steering System .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.