Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 316 (STARTING SYSTEM)DIAGNOSTIC INFORMATIONDTC P0563TESTING
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
DTC P0563: Testing
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Testing
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Did you perform the DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL? If so, go to next step. If not, go to DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL .
- Turn OFF all the accessories. Measure the battery voltage at the battery using the DMM. Operate the engine speed above 2000 RPM. Is the battery voltage less than the specified value of 19V? If so, go to step 4. If not, go to next step.
- Replace the generator. See GENERATOR & REGULATORS . After replacement is complete, go to step 5.
- Replace the PCM. See POWERTRAIN CONTROL MODULE in REMOVAL, OVERHAUL & INSTALLATION . After replacement is complete, go to next step.
- Select the DIAGNOSTIC TROUBLE CODE (DTC) option and the CLEAR DTC INFORMATION option using the scan tool. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text, if applicable. See CONDITIONS FOR RUNNING THE DTC . Does the DTC reset? If so, go to step 2. If not, then system is okay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.