SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 298 (CHARGING SYSTEM)ON-VEHICLE TESTINGENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECKDIAGNOSTIC PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Diagnostic Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Diagnostic Procedure
WARNING: This page is about a different car, the 2003 Oldsmobile Aurora and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform battery inspection test. See BATTERY TESTING & INSPECTION  under ON-VEHICLE TESTING. After performing battery inspection, go to next step.
  2. Connect scan tool to DLC. See COMPONENT LOCATIONS  . Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, see BODY CONTROL MODULES - AURORA article in ACCESSORIES & EQUIPMENT.
    3. NOTE: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  3. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool. Rotate the ignition switch through all positions while observing the Class 2 Power Mode parameter. The ignition switch parameter reading should match the ignition switch position for all switch positions. If reading is as specified, go to next step. If reading is not as specified, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  4. Turn ON the ignition, with the engine OFF. Attempt to communicate with each of the following modules on the class 2 serial data circuit:
    • Instrument Panel Cluster (IPC).
    • Dash Integration Module (DIM).
    • Powertrain Control Module (PCM).
    The scan tool should communicate with all modules on the class 2 serial data circuit. If communication is as specified, go to next step. If communication is as not specified, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  5. Using scan tool, select DISPLAY DTC function for DIM, IPC and PCM. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, diagnose by symptom. See SYMPTOM INDEX  table under SYSTEM TESTS.
  6. If scan tool does not display DTCs which begin with "U", go to next step. If scan tool displays DTCs which begin with "U", perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS in BODY CONTROL MODULES - AURORA article in ACCESSORIES & EQUIPMENT.
  7. If scan tool displays DTC B1000, B1004, B1007 or B1009, repair these DTCs first. See BODY CONTROL MODULES - AURORA article in ACCESSORIES & EQUIPMENT. If scan tool displays any other DTCs, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.