Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 190 (SERVICING - A/T (VT25-E))REMOVAL & INSTALLATIONCONSOLEINSTALLATION
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Removal & Installation: Console: Installation
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Position the console on top of the center floor console. See Figure .
- Install the console screws. Tighten the screws to specification. See TORQUE SPECIFICATIONS .
- Connect the electrical connector to the auxiliary power outlet. See Figure .
- Reposition the center console.
- Install the cup holder screws. See Figure . Tighten the screws to specification. See TORQUE SPECIFICATIONS .
- Install the cup holder liner.
- Reach under the front seats to access the lower console screws.
- Install the center console screws. See Figure . Tighten the screws to specification. See TORQUE SPECIFICATIONS .
- Position the front seat forward to the original position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.