Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 189 (AUTOMATIC TRANSMISSION REMOVAL & INSTALLATION)TORQUE SPECIFICATIONS
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Torque Specifications
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Torque Specifications
WARNING: This page is about a different car, the 2003 Pontiac Aztek, 2003 Buick Rendezvous, 2002 Pontiac Aztek, and 2002 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Brace-To-Engine Bolts | 32 (43) |
| Brace-To-Transaxle Bolts | 32 (43) |
| Engine Mount Strut Bolts & Nuts | 35 (48) |
| Frame Bolts (Front) | 114 (155) |
| Frame Bolts (Rear) | 177 (240) |
| Lower Transaxle-To-Engine Bolts | 55 (75) |
| Transaxle Oil Cooler Hose Retainer & Bolt | 18 (25) |
| Transaxle Range Selector Lever Nut | 15 (20) |
| Upper Transaxle Bolts & Studs | 55 (75) |
| Wheel Drive Shaft Nut | 192 (260) |
| INCH Lbs. (N.m) | |
| Air Cleaner Housing Bolts | 89 (10) |
| Fluid Filler Tube Bolt & Nut | 115 (13) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.