SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 151 (DOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEM)REPAIR INSTRUCTIONSHANDLE BEZEL REPLACEMENT - INSIDE - FRONTREMOVAL PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The bezel on the front inside door handle has an electrical connector for the power door lock system.

  1. Remove the inside door handle bezel screw.
  2. Using a small, flat-bladed tool, remove the inside door handle bezel from the door trim panel.
  3. Remove the inside door lock electrical connector.
  4. Remove the inside door handle bezel radio speaker electrical connector.
  5. Remove the inside door handle bezel from the vehicle.
    6. Fig 1: Identifying Front Door Handle Bezel
    G01755786Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.