SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 148 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL CABLE REPLACEMENT (3.8L)REMOVAL PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable. Refer to Cruise Control Description and Operation  for the complete operational details.

  1. Remove the cruise control cable from the throttle lever and the accelerator control cable bracket.
    2. Fig 1: Identifying Cruise Control Cable At Throttle Lever & Accelerator Control Cable Bracket
    G01755470Courtesy of GENERAL MOTORS CORP.
  2. Remove the cruise control cable from the cruise control cable retainers.
  3. Remove the cruise control cable from the cruise control module strap.
    4. Fig 2: Identifying Cruise Control Module Strap
    G01755471Courtesy of GENERAL MOTORS CORP.
  4. Remove the cruise control cable from the cruise control module by rotating the cruise control cable counterclockwise.
    5. Fig 3: Removing Cruise Control Cable From Cruise Control Module
    G01755472Courtesy of GENERAL MOTORS CORP.
  5. Remove the cruise control cable from the engine.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.