Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (BODY CONTROL MODULES)DIAGNOSTIC TESTSDTC B1009: EEPROM CHECKSUM ERRORTEST PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Test Procedure
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Test Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- If diagnostic system check for system exhibiting symptom has been performed, go to next step. If diagnostic system check for system exhibiting symptom has not been performed, perform appropriate diagnostic system check for suspect system. See BODY CONTROL SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Connect scan tool to Data Link Connector (DLC). DLC is located below driver side of instrument panel, near steering column. Turn ignition switch to RUN position. Using scan tool, retrieve DTCs. If DTC B1009 is retrieved as current in any module except DIM, perform calibration/setup procedure. See PROGRAMMING . Using scan tool, clear DTCs. Operate vehicle within code enable criteria. See CODE ENABLE CRITERIA . If DTC B1009 resets, go to next step. If DTC B1009 is not retrieved as current, see DIAGNOSTIC AIDS .
- Replace control module. Program control module, if necessary. See PROGRAMMING . After repair, go to next step.
- Using scan tool, clear DTCs. Operate vehicle within code enable criteria. See CODE ENABLE CRITERIA . If DTC resets, repeat test beginning at step 2.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.